| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mach Software (ArtSoft software) Discuss Mach 1 , 2 and the new Mach3 here NC software here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#2
 
12-09-2011, 01:33 PM
| |||
| |||
| I've never tried it but I would first make sure that you don't have a G code at the start of your program that is cancelling what you put in. If that doesn't work, then maybe you need to specify something in G code to get it to use those settings. Hav eyou read in the manual about it? Matt  |
|
#3
12-09-2011, 05:17 PM
| ||||
| ||||
| The wear diameter values in the tool table aren't used for anything in Mach3. Not sure why they are being reset, but again, they don't do anything anyway.
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Very Little Wear! | keen | Tormach PCNC | 11 | 09-03-2010 04:36 PM |
| Need Help!- Fanuc O-M, D and D-wear | bob@apc | Fanuc | 3 | 02-26-2008 07:46 AM |
| Bit wear? | HakBot | Benchtop Machines | 6 | 12-02-2007 09:45 AM |
| Does a CNC wear out? | Bear | Mazak, Mitsubishi, Mazatrol | 7 | 06-12-2006 05:46 PM |
| Nut wear | avsfan733 | DIY-CNC Router Table Machines | 6 | 12-18-2003 05:14 PM |
| | |
Linear Mode
