| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mach Software (ArtSoft software) Discuss Mach 1 , 2 and the new Mach3 here NC software here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
08-16-2011, 04:37 PM
| |||
| |||
My machine units are mm. My dial gauge is inches. mach3: Is there a way to specify a different unit in the steps per unit setup? I could just do the math I suppose - but what fun is that? -frige  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Configuring steps/unit.....what unit? | HereinCS | Mach Software (ArtSoft software) | 2 | 03-07-2011 07:57 PM |
| H E L P - - - Steps Per Unit | tjskcnc | Mach Software (ArtSoft software) | 7 | 11-26-2009 04:32 AM |
| Cant get steps per unit right no matter what | idtkid | Mach Software (ArtSoft software) | 26 | 06-30-2009 11:14 PM |
| Steps per unit is all messed up??? | mwalach | Mach Mill | 2 | 02-18-2007 11:50 AM |
| Set-up / Steps per Unit / Threads per Inch | adda | Mastercam | 2 | 01-15-2007 04:29 PM |
| | |
Linear Mode
