I have a maxnc cl15 (dont laugh it"s what I got) Any way I am having a lot of trouble trying to get the spindle to run. If I set config, to PWM then I can start the spindle (m03 m05) But I cant control the motor speed.
If I use Step&Direction the motor wont start at all.
When I go to diagnostics page & toggle the spindle the light on output #1 flashes then goes out. Is there some Pin&port that I should se and does anyone know what it would be. All the help I can get would be really appreciated.
Not knowing anything about the maxnc cl15, I can't tell you anything specific.
The VFD for the spindle may require a 0-10v signal from the control.
can you source a manual and pinouts from the manufacturer?
How are you trying to control spindle speed? s1000.s1500,s2000 etc in the gcode!