| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mach Software (ArtSoft software) Discuss Mach 1 , 2 and the new Mach3 here NC software here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
06-15-2011, 07:11 PM
| |||
| |||
Hello. I have set Mach 3 to output to the rogers encoder interface board but on the diagnosis screen it appears that none of the outputs on port #1 (port 2 is not installed) are activating. Is there a program that makes it possible to manually pulse from the parallel port, so that I can know if the board or mach 3 is in error here? thanks.  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| can you help me? Parallel Port | juju7 | Mach Software (ArtSoft software) | 2 | 02-11-2011 08:09 AM |
| USB to Parallel port?? | willio | Shopmaster/Shoptask | 25 | 11-12-2009 02:42 PM |
| parallel port or parallel universe | bruno34 | Taig Mills & Lathes | 5 | 04-15-2009 10:58 AM |
| Where's the parallel port? | cdlenterprises | Mastercam | 23 | 01-20-2007 05:23 PM |
| Second parallel port? | essa | LinuxCNC (formerly EMC2) | 11 | 04-12-2006 02:18 AM |
| | |
Linear Mode
