Mach 3 "Software Limits!" message in status bar?

[Com_VC]

Hi,

I have been playing around with mach3 tonight, it was working fine and all of a sudden it came up with "Software Limits!" message in the status bar and nothing will work now as it is stuck in emergency stop mode and I cannot reset it.

Anyone know what this means?

Thanks

[ger21]

Turn off Soft Limits. You must have been outside the range of your softlimit settings (on Config > Homing/Limits) when you enabled softlimits.

[Com_VC]

Thanks, it works again, I haven't broken anything. *yet*