| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mach Software (ArtSoft software) Discuss Mach 1 , 2 and the new Mach3 here NC software here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
08-22-2005, 11:05 PM
| |||
| |||
when i try and finish the end of the stup it says that it is unable to complete setup because i do not have windows nt 4.0 . i am running windows 98, which i thought would supercede but i was not sure, could you guys point me in the right direction of a free download, i am already overbudget on the cnc project...  |
|
#2
08-23-2005, 03:42 AM
| |||
| |||
| Unfortunately you need either Windows XP or Windows 2000 to run the Machx software. You might want to try Master 5 from artsoft, but obvioulsy it is not nearly as good as Mach2. If you can, upgrade your version of windows. Sorry! If you don't mind running DOS, you couldtry turbocnc from www.dakeng.com too.
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
