Auto defining of Motor Pins in Mach 3 - CNCzone.com-The Largest Machinist Community on the net!

Barefootboy4 · #1 03-13-2011, 09:19 AM

I have had a computer crash and now starting from sctatch. I did not write down my motor ports and pins. I remember the Mach 3 has a way of telling you which port and pin each motor is hooked up too. How does oen do this. I cannot find it again in Mach 3 anywhere??

jeffrey001 · #2 03-14-2011, 04:48 AM

This is not possible.

The only auto detect in Mach3 is on the inputs

It will detect when you press a switch connected to the parallel port.

It is impossible for mach to know what port and pin you motor are.

Jeff

mactec54 · #3 03-14-2011, 08:02 AM

Barefootboy4

If you have the XML file that will get you going, & do what you want to do

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Output pins in Hobby CNC PRO BOARDS and Mach 3	Rene Nuñez Paz	Hobbycnc (Products)	6	06-01-2010 07:59 PM
Need Help!- AUTO TOOL ZERO WITH MACH 3	feragto	Mach Wizards, Macros, & Addons	1	12-12-2009 12:49 PM
Pulse Motor for Auto Feed?	EvilSmirk	Mini Lathe	1	09-15-2009 10:48 AM
the motor rotates in jog but no in auto	PRIOR666	Fanuc	4	06-28-2007 02:03 PM
Confused in Mach 2 enable pins config,it's mapping to XYZ or not?	szcharle	General CNC (Mill and Lathe) Control Software (NC)	0	02-15-2007 05:23 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)