| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mach Software (ArtSoft software) Discuss Mach 1 , 2 and the new Mach3 here NC software here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#3
 
03-09-2011, 06:03 PM
| |||
| |||
| can you tell me how to do it too?  |
|
#4
03-09-2011, 06:49 PM
| ||||
| ||||
| Go to the MDI screen, click in the MDI box, or it "enter", and type in a line of g-code. When you hit enter again, it will execute the line of code.
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Mach 3 Losing Z Position | TaK | Mach Software (ArtSoft software) | 1 | 12-03-2010 09:36 PM |
| z position setup in mach 3 | Runner4404spd | Industrial Hobbies (Support forum) | 6 | 11-30-2008 05:28 AM |
| can this be programmed manually? | 300sniper | G-Code Programing | 25 | 02-14-2008 10:07 PM |
| Manually Change Endmill | DroopyPawn | G-Code Programing | 9 | 11-20-2007 01:04 AM |
| How to remember the position after close MACH program?? | jimmychand | Mach Software (ArtSoft software) | 1 | 05-25-2007 07:51 AM |
| | |
Linear Mode
