| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mach Software (ArtSoft software) Discuss Mach 1 , 2 and the new Mach3 here NC software here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
09-18-2010, 06:47 PM
| |||
| |||
What is going on here. Measured backlashes on my machine today (0.0007 and 0.0012 X and Y), so entered those values in backlash dialog. Accuracy is now great! However my machine behaves totally wonky. Jogging and any G code execution is associated with slowing down to a crawl each time X and Y change directions. I tried backlash speed control anything from 1 to 10000% of the max to no avail. Using machine is simply not practical anymore and it doesnt hold feed constant (as before). What do I do wrong???  |
|
#2
09-18-2010, 08:18 PM
| ||||
| ||||
| You need to adjust the shuttle accel setting in general config. Not sure what it should be, though.
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Okuma mill feed rate jumps to rapid feed | easyguy97 | Okuma | 6 | 12-20-2009 04:14 AM |
| Backlash Compensation / Backlash | dwessels | Benchtop Machines | 58 | 02-23-2009 10:27 AM |
| Backlash or motor tuning problem? How do I test for backlash? | Brian Queen | Mach Mill | 8 | 03-10-2008 03:35 PM |
| Advice on setup / speed / feed for 1/2" Radius corner rounding end mill | peter.blais | General Metalwork Discussion | 2 | 05-23-2007 03:16 AM |
| Servo idea - elimated backlash - zero backlash ! | synthetiklone | Linear and Rotary Motion | 6 | 12-06-2006 01:35 PM |
| | |
Linear Mode
