| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mach Software (ArtSoft software) Discuss Mach 1 , 2 and the new Mach3 here NC software here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
06-15-2005, 08:52 AM
| ||||
| ||||
Didn't really see a better forum for this question......hope this is the right place. I am looking for specifics on controlling spindle speed with a Mach/gecko retrofit on both a Bridgeport V2XT and also a Boss5. Can anyone help with this? Thanks Scott  |
|
#2
06-15-2005, 09:06 AM
| ||||
| ||||
| Do you need a 0-10V signal for a VFD? http://www.campbelldesigns.com makes a Mach2 compatible board for this.
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| CNC Controlled Spindle motor speed control | gregmary | General Electronics Discussion | 13 | 02-27-2009 07:01 PM |
| How to set a relay for a spindle motor ON/OFF control | TTaki | TurboCNC | 2 | 03-09-2005 06:26 AM |
| Spindle Speed & Feed Rates - Question | Moondog | DIY-CNC Router Table Machines | 1 | 07-23-2004 06:24 PM |
| CNC spindle and fluid control | replicapro | General Electronics Discussion | 0 | 06-22-2004 01:37 PM |
| AC Speed Control | georgebarr | General Electronics Discussion | 7 | 01-06-2004 07:33 PM |
| | |
Linear Mode
