| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mach Software (ArtSoft software) Discuss Mach 1 , 2 and the new Mach3 here NC software here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
07-31-2010, 12:53 PM
| |||
| |||
Hello, I am trying to get my system running and would like advise on setting up Mach3. My system: Windows 7 (Bootcamp Macbook Pro) SmoothStepper G540 Kelingtech motors and PSU. I see there are .xml files to set up Mach3 for the G540 and Smooth Stepper. Which order should I install them? Should I install the .xml file for the G540, then do a manual setup for the SmoothStepper? I am communicating properly with the SmoothStepper per the 2 steady lights and one blinking. The G540 is out of fault mode, but I cannot jog the steppers. Thanks for any help, Jeff  |
|
#2
07-31-2010, 12:56 PM
| ||||
| ||||
| I've never used either, so can't help much. You can't use both .xml files. One will overwrite the other.
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Smooth stepper | dnelso | Industrial Hobbies (Support forum) | 5 | 08-04-2009 11:07 AM |
| smooth stepper setup | eloid | DIY-CNC Router Table Machines | 3 | 06-05-2009 07:32 PM |
| trouble with setup of g540 and mach | ZNAK | Mach Software (ArtSoft software) | 1 | 04-05-2009 08:56 AM |
| What is a Smooth Stepper and ... | gotfdirtball | Mach Software (ArtSoft software) | 1 | 03-16-2009 07:43 PM |
| Bridgeport stepper motors mach 3 setup? | wyobmf | Bridgeport and Hardinge Mills | 14 | 12-29-2008 08:15 AM |
| | |
Linear Mode
