| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mach Software (ArtSoft software) Discuss Mach 1 , 2 and the new Mach3 here NC software here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#3
05-28-2005, 07:10 AM
| ||||
| ||||
| Mach3 will only output step and direction signals via the parallel port. An upcoming version (Mach4?) will send signals to the soon to be released Gecko G100 motion controller.
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| RS232 problem sending with newer PC | sys_man | Computers and Networking | 15 | 06-10-2005 08:36 PM |
| RS232 failure to send in XON/XOFF, hangs WAITING, thermally caused. | gar | Haas Mills | 3 | 05-27-2005 07:44 AM |
| Heidenhain TNC310 RS232 | Al_The_Man | Mazak, Mitsubishi, Mazatrol | 5 | 04-27-2005 09:18 AM |
| How to drip link from pc to RS232 port | jamie | General Electronics Discussion | 1 | 02-11-2005 10:54 PM |
| Pc Rs232 > Fanic 10te-f | abselect | General Electronics Discussion | 0 | 07-06-2004 09:23 AM |
| | |
Linear Mode
