| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mach Software (ArtSoft software) Discuss Mach 1 , 2 and the new Mach3 here NC software here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
06-14-2010, 02:34 AM
| |||
| |||
Hi, i have recently finished putting an MP03 pendant together in a redesigned case but am now struggling to get it to work. When i load the MP03 profile (cloned from the original)and plug in supplied with the kit i immediately get an error message telling me the e-stop is not conected to the smoothstepper which it is and works perfectly using my original profile.Mach3 then hangs and i have to reboot. If i can get past the first hurdle i might be able to get it going but electronics is not my forte.Any advise/suggestions greatly appreciated. Aspley  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How setting tools and setting offset | John246 | Sharp CNC | 9 | 03-17-2010 09:31 PM |
| Setting up tools.. advice needed | compunerdy | Tormach PCNC | 4 | 12-20-2009 11:35 AM |
| setting up Mach 2 help needed | reeftoker75 | DIY-CNC Router Table Machines | 7 | 03-28-2006 08:29 PM |
| Pendant? | CNCadmin | Carken Products (Deskam, DeskCNC etc) | 2 | 01-10-2005 09:32 AM |
| Pendant? | CNCadmin | Carken Products (Deskam, DeskCNC etc) | 0 | 05-07-2004 09:10 AM |
| | |
Linear Mode
