| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mach Software (ArtSoft software) Discuss Mach 1 , 2 and the new Mach3 here NC software here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
04-10-2010, 07:24 PM
| |||
| |||
I am using the XS-3525/8S-4 Stepper Motor Driver Board. I have setup all the limit switches and e-stops. They respond properly in the Mach 3 diagnostic page when the board is powered off. However when the board is powered on, I can't reset the software. It says "imit switch triggered". I don't know what is the problem. It works when it's not powered but not working when powered. Any ideas or suggestion? Thanks!  |
|
| Tags |
| mach 3, xylotex |
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| what driver board | smokingbob | Stepper Motors and Drives | 9 | 05-30-2009 12:02 PM |
| Need Help!- Driver Board | belizewood | Teachers Hang out | 0 | 04-15-2009 10:52 AM |
| single axis driver and a b.o.b.,or multi-axis driver board | .xXACEXx. | Stepper Motors and Drives | 3 | 07-02-2007 11:13 PM |
| New and need your help Please (driver board) | Oldmanandhistoy | General Electronics Discussion | 17 | 06-12-2005 04:48 PM |
| driver board | mtaddei | Benchtop Machines | 1 | 11-19-2004 02:13 PM |
| | |
Linear Mode
