| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mach Software (ArtSoft software) Discuss Mach 1 , 2 and the new Mach3 here NC software here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-17-2010, 03:55 PM
| |||
| |||
I bought a new computer and had a 25 pin port installed, also bought the thru/thru cable. I cannot get my motors to move, they lock up under power but thats it. I am running windows vista 32 bit, I run the zip file download on the artsoft site. It there anyway I can tell if my computer is sending the signal to my break out board. I dont have the motors mounted on a machine yet I was just trying to get them going.  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| mach 3 question | vz58 | Benchtop Machines | 3 | 02-14-2010 08:32 PM |
| New Mach 3 question | monte55 | Mach Software (ArtSoft software) | 0 | 02-08-2008 06:56 AM |
| mach III question | woodman08 | Canadian Club House | 2 | 12-23-2007 08:10 PM |
| I know it's a Mach 3 question.... | Smitty911 | Benchtop Machines | 4 | 11-30-2007 07:16 PM |
| Mach 1 question | CNCadmin | Mach Software (ArtSoft software) | 2 | 03-31-2003 12:36 PM |
| | |
Linear Mode
