| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
02-21-2010, 12:17 AM
| |||
| |||
I have been playing with Mach3s Plasma capabilities... and have noticed that when THCup and THCdown are triggered, the Z-axis tries to go full speed without any acceleration. This stalls my motors unless I run them at a slower feed rate, which kinda kills the response of the THC.... Anyone else notice this or better yet know how to fix it??? I have other issues like the THC enable button doesn't seem to work when the parallel port driver is instated, but can get around that by writing my own brains...  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| speed vs acceleration. | ihavenofish | Benchtop Machines | 0 | 08-12-2009 05:57 AM |
| Acceleration/plasma? | KKamel | CNC Plasma and Waterjet Machines | 2 | 03-03-2007 04:03 AM |
| acceleration in curves | Antonio_Latron | TurboCNC | 0 | 09-29-2006 10:12 AM |
| acceleration | Iron Brew | CNC Plasma and Waterjet Machines | 0 | 02-18-2005 09:52 PM |
| Acceleration | Photon | DIY-CNC Router Table Machines | 5 | 06-03-2004 12:46 AM |
| | |
Linear Mode
