| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#2
 
11-10-2008, 06:57 PM
| |||
| |||
| Yes. You need to setup an UP and Down switch (hopefully isolated) into the THC UP and THC DOWN inputs in MACH (Config/ports & pins/Input Signals) Then you need to go into Mill Options and turn on the "Allow THC operations even when not under THC control" checkbox. On all of our MACH based THC interface our I/O breakout cards have isolated inputs for an external UP and DOWN manual control (mostly used for oxy-Fuel cutting). The signals are in parallel with the UP and DOWN signals from our DTHC so you don't have to swap over a bunch of signals for doing plasma or manual cutting. TOM CAUDLE www.CandCNC.com    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| I NEED: DX-32 manual, 1104-2832 VMC Operator's Manual, DX-32 CNC Control | vettespeed | Bridgeport and Hardinge Mills | 25 | 05-01-2011 07:50 AM |
| Problem- Control Running Slow | dpellarin | Fadal | 10 | 07-21-2008 09:31 PM |
| Software for single axis manual control? | Corruptor | General CNC (Mill and Lathe) Control Software (NC) | 0 | 02-07-2008 10:39 PM |
| Move your steppers. Free XP progam. Simple | zippys | General CNC (Mill and Lathe) Control Software (NC) | 1 | 05-21-2007 07:32 AM |
| help me find a nc backplot progam | billy-bob-bo | General CAM Discussion | 1 | 03-09-2007 07:43 PM |
| | |
Linear Mode
