| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
11-06-2008, 05:28 AM
| |||
| |||
Dear Sir, We are trying to using the dmc 2123 controller (with 8 i/o)and mach3 software for laser system. And we download the plug-in for Galil We saw setting for mill in mach3. But we are not able to get proper setting to interface laser. We only need to one out put from mach3 to turn on or off laser Please provide the solution/guidance as soon as possible. Thanks Regards, Nilesh Deshmukh exceltech southasia Andheria,(E),Mumbai Mumbai, Maharastra 400068 India Phone: 91-022-28222323 nilesh@exceltech-southasia.com    |
|
#2
11-06-2008, 11:42 AM
| ||||
| ||||
| Try the Mach Group site if all else fails. I have not looked into the Mach/Galil interface, but am familiar with Galil, and in the Mach, I would assume you need to set up a M code of your choice that should then send either a SBx or CBx, Set Bit/Clear Bit to the Galil card to turn the output on/off. Al.
__________________ “Logic will get you from A to B. Imagination will take you everywhere.” Albert E. (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Mach with Galil or Delta Tau? | TurboStew | Mach Software (ArtSoft software) | 10 | 10-21-2008 10:45 AM |
| Confused: Mach Turn, Mach Mill, Mach 2/3 ? | CanSir | Mach Software (ArtSoft software) | 5 | 02-16-2007 05:41 AM |
| Galil Anyone | Al_The_Man | Servo Motors and Drives | 48 | 10-29-2006 02:52 PM |
| Using Mach for a laser | CNCadmin | Machines running Mach Software | 10 | 08-03-2005 03:59 PM |
| Laser and Mach | CNCadmin | Mach Plasma / Laser | 2 | 06-19-2005 02:34 PM |
| | |
Linear Mode
