| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
05-29-2008, 09:59 AM
| |||
| |||
Im trying to test out for any tripping on the THC Min and Max for my Mach 3 Plasma, but it still seems to go over the limit when i jog up and down my z axis. I've done everything possible to try to make it reach its limit, but its not working. Any suggestions?    |
|
#2
06-26-2008, 08:34 PM
| |||
| |||
| That's because the THC min and max settings under THC, control limits of the Z ( to prevent a tip crash if the cut hits a hole or runs off the edge for example) When jogging the Z is just a normal axis and the THC parameters do not apply. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Help to identify this pile of junk, another trip to the flea market. | Konstantin | General Electronics Discussion | 0 | 02-01-2007 06:17 PM |
| VFD fault trip | colin1544 | Bridgeport and Hardinge Mills | 0 | 09-25-2006 05:48 PM |
| | |
Linear Mode
