Upgrading Mach3 CNC w/MP1000-THC

[ptig185]

Hi all,
I had mach3 cnc V (D1.90.020) set up and running with my MP1000-THC and it was running w/o machine setup yet (no homing switches) but I wanted to
upgrade to the latest rev (R2.63).

I loaded the XML files after installation and I pull up the Profile MP1000-THC
and the screen is half size in both x and y dimensions. (see attached photo)

There is no homing-zeroing bar next to the DRO's either but I do get the Torch height control buttons.

Any ideas?

Thanks,
Brian

[XTCNC]

The screen resolution is incorrect.
Either edit it in screen4 or go to view-load screens and load plasma.set

Regards

XTCNC

[ger21]

Or click Auto Screen Enlarge in general config and restart mach.