| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
04-27-2008, 09:52 AM
| |||
| |||
Hi all, I had mach3 cnc V (D1.90.020) set up and running with my MP1000-THC and it was running w/o machine setup yet (no homing switches) but I wanted to upgrade to the latest rev (R2.63). I loaded the XML files after installation and I pull up the Profile MP1000-THC and the screen is half size in both x and y dimensions. (see attached photo) There is no homing-zeroing bar next to the DRO's either but I do get the Torch height control buttons. Any ideas? Thanks, Brian    |
|
#3
07-26-2008, 06:39 AM
| ||||
| ||||
| Or click Auto Screen Enlarge in general config and restart mach.
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Upgrading Dolphin | ImanCarrot | Dolphin CADCAM | 4 | 03-19-2008 05:13 AM |
| Upgrading a Shopbot | JeffreyMcGrew | Commercial CNC Wood Routers | 7 | 12-28-2007 03:13 PM |
| shopsabre wincnc to MP1000-THC MACH3 | dbrown36 | CNC Plasma and Waterjet Machines | 11 | 10-03-2007 12:32 AM |
| Will this brushless servo/drive/MP1000-THC combo work? | wolfmetalfab | Servo Motors and Drives | 3 | 02-07-2007 07:37 PM |
| MP1000 vs THC-300 | Crayola | CNC Plasma and Waterjet Machines | 1 | 06-07-2006 10:32 AM |
| | |
Linear Mode
