Odd problem

[wiwoods]

I am currently using the trial version of Mach 3 Plasma to test various aspects of the Plasma table I am constructing, and when I run the X and Y axis under Mach 3 plasma only the Y axis responds. After swapping a bunch of stuff around I finally determined that the motors and driver board are OK. On a whim I tried Mach 3 mill and both motors work fine. I checked all the settings for ports, motor tuning, etc., and matched it in Plasma to what I was seeing in Mill, and still no change. I suspect I am missing something yet, any suggestions?

[Dancho]

Yes that's right.I have a similar problems annd I'm working ower it.I hope a new screen wil solve the problem.