speed up axis between cutting operations

[garydunlop]

hi to all metal cutters, could or has anyone found a way to speed x and y axis faster, so say if plasma makes a cut at 700mm/min then jumps to 1500mm/min to move to the next cut and then goes back to 700mm/min to cut the next cut,, is that posible thanks again to all helping thoughts

[ger21]

Increase the velocity in motor tuning. That's what controls your G0 speed between cuts.

Provided your machine can handle the increase, of course.

[garydunlop]

many thanks gur21 now works a treat cheers,,