Need Help! THC300...Fault Light wont go out. - CNCzone.com-The Largest Machinist Community on the net!

towertek · #1 05-12-2011, 06:45 PM

I cant seem to get my THC 300 to work. That fault light is always on, and the torch active LED in Mach3 is off.

Any

suggestions?

jeremyrockjock · #2 05-14-2011, 11:30 AM

How is port 2 communications?

towertek · #3 05-17-2011, 07:19 PM

Port 2 working fine. I sent my unit back to TexasMicroCircuits and they sent it back to me. It still does not work.

No up-down.
Fault lite always on.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Red FAULT light on Gecko 320	schwinndk	Automation Technology Products	51	09-21-2009 01:33 AM
Need Help!- Gecko 320 FAULT light is on	schwinndk	Gecko Drives	0	08-14-2009 09:22 AM
Need Help!- vf4 wont boot up, system fault	fergieman	Haas Mills	3	08-29-2008 09:31 AM
Low Coolant Light Wont Clear	Crashmaster	Hardinge Lathes	5	08-06-2008 07:09 AM
320 fault Light	Ed Williams	Gecko Drives	0	02-05-2008 09:28 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)