| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
06-19-2005, 11:14 AM
| ||||
| ||||
I tried to use the plasma for Mach and noticed that it uses a z. For my laser I just need X,Y and turn on turn off of the laser and the ability to set the strength of the laser. Any thoughts?
__________________ Thank You, Paul G Site Owner-Webmaster- Administrator www.rfqwork.com www.cnczone.com www.welderzone.com    |
|
#2
06-19-2005, 02:33 PM
| |||
| |||
| under "config" "ports and pins" checkout the spindle setup tab. It has a box labeled "special settings",,, with a laser mode frequency by feedrate percentage. Also you can inhibit the Z axis under mill options, and on the settings page |
|
#3
06-19-2005, 02:34 PM
| |||
| |||
| Assuming you're using Mach3 |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| laser digitizing | twombo | Digitizing and Laser Digitizing | 23 | 07-31-2005 09:51 PM |
| | |
Linear Mode
