| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#2
08-10-2010, 10:37 AM
| ||||
| ||||
| Slave it to the Y and reverse it. you can reverse it in Config>Homing Limits (check the reverse box) or by changing the active low setting for the dir pin.
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)  |
|
#3
08-10-2010, 12:53 PM
| ||||
| ||||
| Ensure that they are reversed before you put it on the machine...DAMHIKT  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| mach3 motor tuning | taigfraeser | Taig Mills & Lathes | 9 | 07-03-2010 11:51 AM |
| Newbie- Controlling a servo motor with mach3 | runiko | Servo Motors and Drives | 6 | 11-15-2009 01:13 PM |
| New Machine Build- Mach3 , Config, Motor Tuning problem ( FILM OF MOTOR) | MDF_Markazi | Mach Software (ArtSoft software) | 7 | 04-30-2009 02:15 AM |
| Motor tuning under Mach3 | BAustin | Industrial Hobbies (Support forum) | 3 | 12-23-2006 11:23 PM |
| Mach3 motor tuning question | kn6398 | Machines running Mach Software | 9 | 04-04-2006 10:07 PM |
| | |
Linear Mode
