this is my problem:
I make a G code with lazycam (tried both new and older version, does not solve the problem).
Import it into mach3.
It runs fine for 2-3 minutes.
After this, always at the same part, mach 3 shifts all of the parts to the left (see image).
I have no idea why.
When I import the G code in mach is looks allright on the toolpath viewer, but when it runs it, it goes wrong.
Anyone can help me please?
Last edited by MatD; 11-07-2009 at 06:38 PM.
.zip the code up and post it, tell us roughly at what line number it screws up and someone (me) can have a look at it.