port pin setu[p - direct phase controller - CNCzone.com-The Largest Machinist Community on the net!

08-31-2007, 10:09 PM

Andy Sayno Andy Sayno is offline

Join Date: Aug 2007

Location: Australia

Posts: 1

port pin setu[p - direct phase controller

permalink

I bought a used Taig CNC mill and the controller apparantly has the stepper motors setup in direct phase. Can this work with Mach software or do i need a new controller? Anyone have experience with this would be greatly appreciated

Regards
Andy

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Paralle port controller	szynszyl	General Electronics Discussion	6	05-10-2007 04:26 PM
Parallel port controller	szynszyl	General Electronics Discussion	2	05-01-2007 02:14 PM
serial port controller	eloid	Servo Motors and Drives	1	03-09-2007 09:49 PM
Pc Port Direct Hitachi L200 Connect	Cruiser	Phase Converters and VFD	2	12-13-2006 09:54 PM
B-port retro 3 phase transformer?	zcases	General Electronics Discussion	4	11-06-2005 09:13 AM

All times are GMT -5. The time now is 12:36 PM.