New Hampshire Cnc folks

[ltoy]

Hi, After getting some some inspration from this board I have started a retrofit of an older cnc mill. I have purcahsed some interface boards and such and I have the system moving. However I have come to a point where I am unable to get the system running correct. Is there anyone in the New Hampshire area that would be intrested in helping me get the system tuned so it's usable? I can give a detailed description of the problem and hardware / software that is running if that helps.

[NEATman]

Itoy-
If you are intersted, there is a "Southern NH CNC Club". It is extremely informal, but we have lots of fun, and I am sure we could help out. You are welcome to attend - the next meeting is this Thursday, the 23rd in Kingston, NH. Send me a private message with your e-mail address, and I'll send you an invite and directions.

If you can't make it, there are a few of us running Mach3, and we may be able to help. Also, there are loads of helpful people here on CNCzone who could get you pointed in the right direction.

NEATman