"No g100's found in system" Mach 3

[MillingMaiden]

I'm setting up Mach 3 to be used with G100. When I start up Mach 3 a box pops up with the heading "motion control hardware plugin sensed" and then there is an option to specify G100 as the one I would like to use. (The other option is a printer port) Then next thing that pops up has a heading of "G100 Status" (While the status on the bottom of my mach 3 screen says: "No G100's found in system") The box has a place for a reported G100 address and a box for the G100 netmask which you can enter values into. Next to those empy spaces is a button called Set Temp Address. I've tried to enter the address and netmask and then hit the "Restart Discovery button"
But the Status on the bottom of Mach 3 doesn't change.

My G-rex connection seems to be sending and receiving information.

I'm wondering if I missed a step somewhere. Any ideas on what I did wrong.

Thank you!

[tauntdesigns]

I don't have a G100 but, here's a link to mach video section. look for g-rex intro for testing:
http://www.artsoftcontrols.com/artsoft/videos.htm

Also, at gecko website in the support section, there is a g100-installation.zip file with allot of info in it. here's the link:
http://www.geckodrive.com/support.cfm

If you already have those and this doesn't help, I'm sorry I can't help
Good luck,
Jack