| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
07-25-2007, 03:42 PM
| |||
| |||
Hello All, I am trying to set up a trial version of Mach 3 (mill) to work with a 3rd party break out board. The instructions that came with the board refer to going into 'Config/State'. I have been unable to find that in the Config menu. Am I looking in the wrong place, or do I need to buy the full version to get access to that area? I plan to buy soon, but have to recuperate a little from the cost of the mill. Any help is greatly appreciated. Thanks!! Ian  |
|
#3
07-25-2007, 06:07 PM
| ||||
| ||||
| Config>logic and config>state have been combined into general config in the latest versions.
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
#4
07-25-2007, 08:34 PM
| |||
| |||
| Thanks for the info! I need to turn on macropump. Ian |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| config settings for mach 2 | fidia | General CNC (Mill and Lathe) Control Software (NC) | 3 | 07-04-2007 05:18 AM |
| Confused in Mach 2 enable pins config,it's mapping to XYZ or not? | szcharle | General CNC (Mill and Lathe) Control Software (NC) | 0 | 02-15-2007 05:23 AM |
| State of the art job shop? | MrGixer | CNCzone Club House | 12 | 06-17-2006 12:40 PM |
| Mach 3 config?? HELP | ty1295 | Servo Drives | 3 | 02-20-2006 12:20 PM |
| Mach 2 config questions | randyf1965 | Mach Software (ArtSoft software) | 1 | 04-19-2005 10:05 PM |
| | |
Linear Mode
