| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
07-12-2007, 06:25 PM
| ||||
| ||||
Is there anything in mach or the thc 300 that can multiply feedrates? I notice that the feedrates are much faster than they should be. The Feedrate override when loading a program jumps to a 1200% increase.... Even without a program start?
__________________ Hey check out my website...www.cravenoriginal.com Thanks Marc  |
|
#2
07-12-2007, 07:19 PM
| ||||
| ||||
| The highest Mach3 should let you set the FRO is 300%. Could be a corrupt .xml
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
#3
07-12-2007, 09:26 PM
| ||||
| ||||
How to fix that? The pendent will let go to 9999%, never ran it above 3 or 400. but the program make it go streight to1200%. I had to make the feedrates really low in order to cut prperly....
__________________ Hey check out my website...www.cravenoriginal.com Thanks Marc |
|
#4
07-13-2007, 08:09 AM
| ||||
| ||||
| Delete the .xml file and reconfigure from scratch. Mach backs up the .xml file automatically, you might want to try reverting back to an older one. You should be able to find them in the Mach folder.
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| mach 2-3 pin&port problem | pislik | DIY-CNC Router Table Machines | 10 | 01-05-2012 02:36 AM |
| G202 & Mach 3 problem | Hillcraft | Gecko Drives | 9 | 01-06-2007 12:06 PM |
| Jog problem with Mach 2 | jtriggs | Mach Mill | 0 | 06-15-2006 12:48 AM |
| Mach 2 Estop problem | dentman | Mach Software (ArtSoft software) | 9 | 06-07-2005 07:32 PM |
| mach 2 problem | CNCadmin | Mach Software (ArtSoft software) | 5 | 01-16-2005 02:12 PM |
| | |
Anybody had this problem in Mach 3? 
Linear Mode
