| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
01-30-2007, 01:23 PM
| |||
| |||
Does Mach support a Phase output rather than step/direction? I have read about people getting this to work somehow, but it isn't a feature I've seen published. I have a Taig that I'd rather run on Mach. Thanks.  |
|
#2
01-30-2007, 05:39 PM
| ||||
| ||||
| Look in Ports and Pins...Max NC wave drive.
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Can I convert single phase motor to three phase? | Jim Estes | Phase Converters and VFD | 30 | 01-24-2009 02:41 AM |
| Confused: Mach Turn, Mach Mill, Mach 2/3 ? | CanSir | Mach Software (ArtSoft software) | 5 | 02-16-2007 04:41 AM |
| 0-10V output control with Mach 3? | fatal-exception | Mach Mill | 3 | 01-11-2007 12:39 PM |
| catia NC output with mach 2 cnc? | hpghost | General CNC (Mill and Lathe) Control Software (NC) | 5 | 09-02-2006 12:22 AM |
| Should Mach Support SPI? | JFettig | Mach Software (ArtSoft software) | 18 | 03-24-2006 11:23 PM |
| | |
Linear Mode
