Toolpath display - CNCzone.com-The Largest Machinist Community on the net!

raytor · #1 11-03-2006, 01:37 PM

When you load G code into Mach3 does your toolpath display the anticipated path before you run the code? If so, how do you turn on that feature? My licensed version of Mach3 won't do this although the manual says it should.

raytor · #2 11-04-2006, 08:54 AM

Solution:
Corrupt display.dat file. Delete this file and rerun Mach3.
Hope this helps others.
R

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)