Super Tech mill
I bought a Supertech mill(Taig) microstepper with the Gecko drives, and I want to run it on Mach3. I put a DOS directory on my computer to run the software that came with the machine but the G code programming is too limited so I want to run Mach2 or 3.
I got it to turn the spindle on and off one day, but my brother did something and now all that does is the spindle on light flickers and has to be reset to turn off. But can't get anything else to work. The videos seem to start out with the mill config files setup, and I tried to set the step, ports and pins, outputs etc. according to the book that came with the mill, but nothing has worked yet.
Any thoughts, anyone?