Mach Questions

[Bloy2004]

If the encoders are 8000 quaduature, then you will have to replace them with less ones....that is unless you go with the Gecko G100. It has Mhz speed If so, you also would need to go with Mach4 which is dedicated to geckdrive's G100, and wait for development of the full control.

[Bloy2004]

Originally Posted by ger21 Does that depend on the drives? Edit: I just reread a few posts, and see what you're talking about, so You're probably right.

From what I understand, the final speed relies on all the elements combined. The drives max output voltage, so that the motors can actually achieve those revs/sec (and power), the controller to put out fast enough pulses, the encoder within range.