| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
06-14-2011, 01:14 PM
| ||||
| ||||
Has anyone had any problems with the charge pump or Mach 3 driver shutting down. IF I start a machine and start a job I have had the software just stop outputing to the parrallel port. I have to stop mach3 and restart it to get it going again. If I stop mach3 and restart it will never die again.  |
|
#2
04-02-2012, 07:45 PM
| |||
| |||
| Are you still having this problem? I have/had the same problem. I talked to tech support of the sellers of my BOB and they said I should get a Smooth Stepper. It came today! Said it was most likely caused by electrical noise or the computer I am using. Ethernet version of the smooth stepper. What BOB are you using? Tim |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Charge Pump | cadmonkey | LinuxCNC (formerly EMC2) | 8 | 04-06-2010 01:19 AM |
| Charge pump - do I need this on? | zeeway | Gecko Drives | 17 | 01-05-2010 12:40 AM |
| charge pump | michaelf | Benchtop Machines | 23 | 10-25-2009 05:55 PM |
| charge pump | eloid | DIY-CNC Router Table Machines | 3 | 01-25-2009 09:14 AM |
| Charge pump | mlaws1172 | Screen Layouts, Post Processors & Misc | 0 | 01-03-2006 10:46 PM |
| | |
Linear Mode
