| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
05-30-2011, 05:40 PM
| |||
| |||
Please...does anyone know if is possible to rotate the coordinates on mach3? I'm meaning that I generate G code for my work with the referring points on the lover left. It works not so functionally so I have to rotate my work on the table position and also the initial position on the G code list...I have to rotate the drawing and consequently generate a new G code Streep or there is some nice tip for doing that? Thanks for Your help  |
|
#2
05-30-2011, 05:42 PM
| ||||
| ||||
| G68 Read the manual to see how to use it.
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
#3
05-31-2011, 03:30 PM
| |||
| |||
| Thanks Gerry...!!!! |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Coordinate offset | davidperry3 | Tormach PCNC | 3 | 02-03-2011 07:57 AM |
| Need Help!- Coordinate Rotation G68 | dougtyler | Fanuc | 10 | 09-21-2010 11:00 AM |
| Polar coordinate programing without polar coordinate interpolation. | TimD | Fanuc | 0 | 11-10-2008 07:35 PM |
| Coordinate Display | Regnar | LinuxCNC (formerly EMC2) | 17 | 07-12-2008 03:07 PM |
| coordinate system | kiethnt | G-Code Programing | 6 | 04-26-2007 07:46 AM |
| | |
Linear Mode
