| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
04-26-2011, 07:16 AM
| |||
| |||
Hallo, I don't have any experiment in mach3 software, and this is my first time that I operate this software, maybe I didn't define the software well when I install the software I search after good guide that will explain how to use mach3, Do you know about good site ? Now I have the software without any controller for the CNC I define that pin 2 is the signal for the x axis motor but when I run the software I don't receive any signal in this pin  |
|
#3
04-28-2011, 08:08 AM
| ||||
| ||||
__________________ Bill (the Cat) Shubert |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem- First time help | engineerme | Hobby Discussion | 2 | 01-26-2011 10:23 AM |
| Need Help!- long time reader first time poster | blu333 | General Metalwork Discussion | 0 | 02-21-2010 05:30 AM |
| Time to Buy | Gorillakilla | Stepper Motors and Drives | 3 | 06-24-2008 03:52 PM |
| milling time (not to be confused with hammer time) | barefoot0 | G-Code Programing | 4 | 05-02-2007 06:18 PM |
| X2 Conversion Time (shopping time) | Micro Rotors | Benchtop Machines | 2 | 03-04-2007 11:11 AM |
| | |
Linear Mode
