| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
10-08-2010, 11:01 AM
| |||
| |||
I installed Mach 3 v2.63 on my machine after my PC crashed and wouldn't start. I ran this machine successfully for almost two years. In setting up my pinout in which Z pins out port 1 on pin 6 and 7 stp and dir respectively. I only get clockwise rotation. I swapped out the stepper (IMS Mdrive 23) and that had no result. Swapped keyboard to rule that out. Pinned out onto the X axis and that didn't help. Finally I decide to change the direction pin to 8 instead of 7 because I thought it might be something with the port. That produced no result. I figured before I went any further I would throw it out there. Thanks.  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Grinding and unexpected axis movement if rapiding 2 axis | DarkSabre | Taig Mills & Lathes | 4 | 03-25-2010 11:37 PM |
| Compare Catia and MCX2 for multi axis lathe/4 axis mill | bob1112 | General CAM Discussion | 0 | 10-10-2008 07:15 PM |
| How can I coupling a stepper motor axis directly to other axis? | meknik2001 | Stepper Motors and Drives | 4 | 05-08-2008 01:54 PM |
| One axis (z-axis?) computer controlled testing device | TsThorsell | Stepper Motors and Drives | 3 | 02-07-2008 12:38 PM |
| New Design - Hybrid 3-Axis Router/4-axis Foam Hot Wire Cutter | the__extreme | CNC Wood Router Project Log | 3 | 02-26-2007 02:58 PM |
| | |
Linear Mode
