| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
08-31-2010, 02:33 PM
| ||||
| ||||
Is it possible to wire up a remote "Cycle Start" button? My router has Mach3 and a Campbell breakout board along with XP Eric
__________________ www.widgitmaster.com It's not what you take away, it's what you are left with that counts!  |
|
#2
08-31-2010, 03:09 PM
| ||||
| ||||
| Yep. Wire it to an input pin. Set up the pin in ports and pins, and also set up an OEM Trigger with the hotkey for cycle start (OEM trigger is also in ports and pins.
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
#3
08-31-2010, 07:11 PM
| ||||
| ||||
| Thanks Gerry! Now I need to figure out how to free up wires & pins, and I'm good to go! Eric
__________________ www.widgitmaster.com It's not what you take away, it's what you are left with that counts! |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
