Need Help!- Machine Running Backwards

[MotoGems]

Hello,

The computer that originally ran my SuperX3 using Mach3 died....

Replaced it... loaded Mach3 and Lazycam again and basically everything is working fine ... EXCEPT....

All programs are now running backwards.... it's not really good when the tool needs to Z+ above the work and it wants to go Z-

So, is there any config / something else that i have to tick / change setting???

Any help is appreciated..

Ian
MotoGems.

[Greolt]

Reversing axis directions is done under Menu /Config / Homing/Limits

Greg

[TarHeelTom]

May I suggest that until you are happy with the operation of the new computer (or any new setup) that you either unplug the Z axis stepper or servo, or remove the tool and tool holder from the spindle.

On a knee mill you'd probably just lower the knee until the quill couldn't reach anything.

[MotoGems]

Originally Posted by Greolt Reversing axis directions is done under Menu /Config / Homing/Limits Greg

Thank you... the problem was fixed in about 1 minute....

Thank you again!!

Ian
MotoGems.