LinkBack URL
About LinkBacks
Are you sure both settings are the same? If they are, you're possibly (probably) losing steps on one axis.
| | |
i have my y axis slave with A, the motor tune is the same, but when i run back and forth on the table and then check it, it is 5/8" off from the other slaved axis. can someone help.
Are you sure both settings are the same? If they are, you're possibly (probably) losing steps on one axis.
Gerry
Mach3 2010 Screenset
http://home.comcast.net/~cncwoodworker/2010.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
so is there a way to find out if that is the problem?
Posting Permissions
| | |
