| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
04-10-2010, 02:53 AM
| |||
| |||
can anyone confirm that mach 3 will recognise the K variable in a G02 or G03 command when machining curves that run on XZ or YZ plane? Also when used in conjuction with G18 G19 the controller on my machine unfortunately will not, so i am considering converting to mach 3! many thanks  |
|
#2
04-10-2010, 07:20 AM
| ||||
| ||||
| Yes, it will. I've cut G18 arcs before using I,K.
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Newbie- Circular Interpolation | Deadwood | Mach Software (ArtSoft software) | 3 | 01-11-2009 02:35 PM |
| nx5 how to turn off circular interpolation | boofa | General CAM Discussion | 5 | 05-27-2008 02:03 PM |
| circular interpolation | sqatch | Dolphin CADCAM | 9 | 02-11-2008 12:02 AM |
| Circular or Helical Interpolation? | meme | General Metalwork Discussion | 6 | 10-30-2007 03:05 AM |
| question about circular interpolation | warpedmephisto | Benchtop Machines | 13 | 03-22-2006 04:51 PM |
| | |
Linear Mode
