| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-21-2010, 06:34 PM
| |||
| |||
I am not sure if I am in the right forum, but here goes. I have been scouring the forums for instructons on how to set up a relay for the router spindle. I have found losts of instructions as to the g-code to produce the start stop effect, but nothing about hardware requirements. I have a Geck0540, and a FOTEK SSR-25 DA relay, do I need more hardware? How in the heck do I hook my router up to this thing? Crash5050  |
|
#2
03-21-2010, 08:05 PM
| ||||
| ||||
| You can buffer it with a 2n7000 directly off the parallel port and use the PC 12vdc supply. http://www.cnczone.com/forums/showth...ghlight=2n7000 Just substitute the mechanical relay for the SSR. Al.
__________________ CNC, Mechatronics Integration and Machine Design. “Logic will get you from A to B. Imagination will take you everywhere.” Albert E. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Help!- NEE - AMC Control on Onsrud Router | MarkT | Commercial CNC Wood Routers | 5 | 04-06-2012 10:32 PM |
| Router speed control | tanky321 | DIY-CNC Router Table Machines | 12 | 03-30-2008 12:34 PM |
| Router speed control | dwacker | DIY-CNC Router Table Machines | 16 | 05-21-2007 02:10 PM |
| control spindle for 2.5-3 hp router | eloid | CNC Wood Router Project Log | 7 | 02-25-2007 10:15 PM |
| Router speed control | ljoe1969 | General Electronics Discussion | 4 | 08-01-2005 08:13 AM |
| | |
Linear Mode
