drill setup in mach lathe - CNCzone.com-The Largest Machinist Community on the net!

01-05-2008, 07:57 AM

Runner4404spd Runner4404spd is offline

Join Date: Jun 2005

Location: USA

Age: 33

Posts: 916

Runner4404spd is on a distinguished road

drill setup in mach lathe

permalink

i'm trying to setup a center drill and a 1/8 drill in my tool table. there doesn't seem to be any drill offsets available. do you just program them into a tool spot and go for it without entering them into the table?

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
HELP ME- taig and mach 3 setup	hollyfeneht	Taig Mills & Lathes	21	02-05-2007 01:57 PM
speed of mill/drill with mach 3?	Runner4404spd	Mach Software (ArtSoft software)	4	12-13-2006 10:55 AM
servo setup questions for mach 3	planeflier	Mach Mill	2	06-05-2006 09:08 PM
Mach 2/3 with VFD setup	zcases	Mach Software (ArtSoft software)	3	10-13-2005 12:14 PM
i have 620 oz steppers 600 pound mill/drill anyone have similar setup?	mike10	Stepper Motors and Drives	0	10-01-2005 06:40 PM

All times are GMT -5. The time now is 06:59 AM.