F15 is the probing feedrate. Reduce the 15 to a smaller number.
Hey,
Is there any way to slow down probing "G31Z-20F15".
I use macro for probing but the feed rate is too big (in my opinion), so I want to change it, but it does not work at all.
Best Regards
Amnon
Similar Threads:
F15 is the probing feedrate. Reduce the 15 to a smaller number.
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Hey ger21,
Thank's for your response.
I did it, I put F5 but despite the fact, that this value was put in DRO, the real (Z axis) feed rate was the same. I do not know why the feed rate did not change.