As I said on the Machsupport forum, you need to plug a USB cable into you breakout board to provide the 5V power it needs.
I have a new installation and I'm trying one stepper motor first. I have Mach3 on windows 10 with a usb cable going a UC100 motion controller (not Chinese) connected to an ST-V2 breakout board. I have a 15 volt power supply to the breakout board. I have all the wiring correct (triple checked) and have pins 2 and 3 selected for the x drive. I get no motor action. No voltage to the DIR or PUL when I try to jog the motor. Both lights are on, on the back of the UC100. I'm not getting 5 volts from the PC5V breakout board connection that feeds the stepper controller. Not sure what to do. Any help would be appreciated.
Similar Threads:
As I said on the Machsupport forum, you need to plug a USB cable into you breakout board to provide the 5V power it needs.
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)