Mach3 is running in demo mode.
Do you have a license?
Good Evening Gents,
I'm put coming up on the completion of my G0704 Hoss conversion, and tonight for the 1st time since putting the system back together. I tried to run the example G-codes that come with Mach3. I have run them before with just the motors connected to my controller and they ran without issue, but tonight no luck. The complete g-code would load and it would start when I started the cycle but would only run about 400 lines, and I noticed that when I regenerate the tool path only a small portion of the objects path gets regenerated. Can anyone please explain to me what I am doing wrong.
Thanks in advance
Similar Threads:
Mach3 is running in demo mode.
Do you have a license?
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Yes, it good. I had been running the example codes with the motors disengaged from the mill and completely regenerating the toolpath. Now I only get a very small portion of the toolpath and it doesn't complete the run. Could I have accidently turn on demo mode when I was setting up it the garage tonight? If so how do I get it out of demo mode
You're name should be displayed in the title bar, or in the Help > About window.
If not, then you're license is not working, or not installed.
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)