Hello,

I apologise immediately if this is such this is a very common question. We are very inexperienced in mach3 and we are trying to get our motors moving for the first time. We gave taken the rar file from our supplier and tried to use the settings they gave us to test one motor.
We have two nema 23s geared motors on the z axis then four nema34 geared motors on x axes and y axes.
We are just basically struggling to get our motors to move. All the wires are connected.

Here are links for the breakout board and stepper motors:
Gear Ratio 47:1 Planetary Gearbox High Torque Nema 23 Stepper 23HS30-2804S-PG47!detail
Gear Ratio 13 1 Spur Gearbox High Torque Nema 34 Stepper Motor 34HS38 4004D SG13!detail
https://www.automationtechnologiesin...face-breakout/

Can anyone point out any common reasons as to why the motors may not be moving at all on the mach3 software?

Similar Threads: